密相塔半干法烟气脱硫塔内加湿降温及其对脱硫效率的影响

为了实现密相塔半干法脱硫工艺的精确加湿进一步提高系统脱硫效率,利用推导出的传热传质计算方法,得到烟气温度降低和加水量的关系.结合3组密相塔半干法工程实际数据,发现理论计算值和实测值误差区间仅为2.9％ ～5.4％.通过选取河北某钢厂210 m2烧结烟气密相塔半干法脱硫项目实际在线检测数据,发现循环脱硫灰含湿量为3％的系统脱硫效率整体高于含湿量为5％和4％的样品,最大值达93.56％.通过粒度分析、扫描电镜、X射线衍射及差热-热重对2种不同含湿量的循环脱硫灰进行表征,结果表明,含湿量为3％的循环脱硫灰较含湿量为5％的样品粒径小、比表面积大,无团聚现象,物相分析还证实相对于含湿量为5％样品,其Ca(OH)2和结晶水含量少,几乎都是CaSO4和CaS03干态物质,因此脱硫反应进行彻底,脱硫效率较高.     

页岩对污泥氨气挥发的抑制作用

氨气是城市污水污泥产生的恶臭气体之一,控制或抑制其产生是资源化利用甚至处置过程中至关重要的.通过改进氨气测量方法定量分析外掺页岩对污泥氨气挥发的抑制作用和机理,实验研究了页岩掺量、陈放形式以及环境温度对污泥氨气挥发浓度的影响.结果表明,外掺页岩对污泥氨气挥发具有明显的抑制作用,随温度升高、陈放时间延长抑制效果有所减弱但仍具有明显作用;页岩对污泥氨气挥发的抑制作用主要为对氨气的吸附作用.     

羟胺强化Fenton反应降解水中氯酚

针对传统Fenton体系Fe（Ⅲ）累积和pH适用范围过窄等缺点，采用羟胺（HA）强化的HA-Fenton体系，以对氯苯酚（4-CP）为目标污染物进行降解实验，考察了Fe（Ⅱ）投加量、H2O2投加量、HA投加量和溶液pH等工艺条件对4-CP去除率的影响。实验结果表明：HA-Fenton体系适用于酸性和弱酸性条件，最佳pH范围为3.0~4.0；在溶液pH为3.0、Fe（Ⅱ）投加量为5.0 μmol/L、H2O2投加量为0.4 mmol/L、HA投加量为0.20 mmol/L的最适条件下，反应10 min， 4-CP去除率达64.25 %。     

磷矿浆催化氧化湿法脱硝研究

采用液相催化氧化NO_x的方法,通过磷矿浆中过渡金属离子的催化作用,达到净化电厂烟气中NO的目的。考察了烟气含氧量、吸收温度、磷矿浆固液比及气体流量对磷矿浆湿法脱硝的影响。结果表明,试验最佳条件为NO进口质量浓度670 mg/m~3、磷矿浆吸收温度25℃、固液比500 g/L、流量0.3 L/min、含氧量20%;优化条件下的磷矿浆脱除效率最高可达88.9%。随着磷矿浆湿法催化氧化脱硝反应的进行,p H值不断下降,导致磷矿浆逐渐失效,需补入新鲜矿浆,维持吸收液的p H值以保证良好脱硝率。     

三峡水库蓄水期不同调度方案对洞庭湖出口水位的影响

洞庭湖水情受到长江和四水的综合影响，因此三峡水库蓄水运行必将对洞庭湖出口水位产生影响。通过构建模型对洞庭湖出口的水位过程进行模拟，以三峡出库日均流量、洞庭湖四水合成日均流量为输入，城陵矶站日水位过程为输出，以量化和分析城陵矶水位变化受三峡水库调度的影响。通过三峡入库流量代替出库流量，还原自然状态下的水位过程，并根据各调度方案计算的出库流量模拟各调度方案下城陵矶的水位变化过程。对比各调度方案下三峡水库蓄泄水对洞庭湖出口水位的影响可以发现：各蓄水方案对洞庭湖出口水位都造成了一定的影响，起蓄时间较早的方案影响时间较长，整体上平均水位变化也较大，但起蓄后水位变化较为平缓；起蓄时间较晚的方案影响时间较短，整体上平均水位变化相对较小，但起蓄后水位变化较为剧烈。考虑到不同年份和不同来水类型情况对洞庭湖出口水位的影响存在差异，各蓄水方案的优劣需要具体分析和讨论     

3种喹诺酮类抗生素在骆马湖饮用水源地沉积物上的吸附特征

为探究喹诺酮类抗生素(QNs)在饮用水源地的吸附特征,2019年6月于江苏骆马湖饮用水源地采集沉积物样品,用5种动力学方程拟合沉积物对诺氟沙星(NOR)、环丙沙星(CIP)和氧氟沙星(OFL)的吸附动力学过程,并用Langmuir和Freundlich模型拟合以上3种QNs的吸附热力学过程,分析了pH、水土比和不同Na~+、Ca~(2+)、Mg~(2+)、Al~(3+)浓度对吸附过程的影响。结果表明:骆马湖沉积物对3种QNs的吸附在8h达到平衡,准二级动力学方程和Langmuir模型能更好地描述3种QNs的吸附动力学和热力学过程。酸性条件下,3种QNs的吸附效果更好,且在pH=5时平衡吸附量最大。平衡吸附量随着水土比的上升而下降。Na~+对吸附的抑制作用不明显,Ca~(2+)和Mg~(2+)的抑制作用较强,而Al~(3+)对吸附表现为促进作用。应在枯水期和南水北调时期加强对骆马湖饮用水源地(尤其是东北部)QNs污染的关注。     

基于AHP-熵权法的基层地震科普能力评价*

为提高基层地震科普评价工作的客观性和精准性，根据“环境-投入-产出-效果”的评价框架，建立涵盖保障能力、队伍能力、设施能力、产出能力、活动能力5类26项指标的基层地震科普能力评价指标体系，选用AHP-熵权法计算指标的组合权重；以天津为例进行验证，并提出相关工作建议。结果表明:建立的评价模型对于开展定量化的区域基层地震科普能力评价具有较强的参考价值，评价结果与实际情况基本相符；天津市基层地震科普在硬件建设方面取得较好成效，但整体能力依然偏弱，16个区平均得分仅为0.344 8；发展不平衡、软实力不足是制约当前发展最重要的2个因素；提出相关的工作建议可为优化基层科普工作布局、提高工作实效提供有益参考。     

Biogenic palladium prepared by activated sludge microbes for the hexavalent chromium catalytic reduction: Impact of relative biomass

• Pd nanoparticles could be reduced and supported by activated sludge microbes. • The effect of biomass on Pd adsorption by microbes is greater than Pd reduction. • More biomass reduces Pd particle size, which is more dispersed on the cell surface. • When the biomass/Pd add to 6, the catalytic reduction rate of Cr(VI) reaches stable. Palladium, a kind of platinum group metal, owns catalytic capacity for a variety of hydrogenations. In this study, Pd nanoparticles (PdNPs) were generated through enzymatic recovery by microbes of activated sludge at various biomass/Pd, and further used for the Cr(VI) reduction. The results show that biomass had a strong adsorption capacity for Pd(II), which was 17.25 mg Pd/g sludge. The XRD and TEM-EDX results confirmed the existence of PdNPs associated with microbes (bio-Pd). The increase of biomass had little effect on the reduction rate of Pd(II), but it could cause decreasing particle size and shifting location of Pd(0) with the better dispersion degree on the cell surface. In the Cr(VI) reduction experiments, Cr(VI) was first adsorbed on bio-Pd with hydrogen and then reduced using active hydrogen as electron donor. Biomass improved the catalytic activity of PdNPs. When the biomass/Pd (w/w) ratio increased to six or higher, Cr(VI) reduction achieved maximum rate that 50 mg/L of Cr(VI) could be rapidly reduced in one minute.     

Locally enhanced electric field treatment (LEEFT) for water disinfection

• Nanowire-assisted LEEFT is applied for water disinfection with low voltages. • LEEFT inactivates bacteria by disrupting cell membrane through electroporation. • Multiple electrodes and device configurations have been developed for LEEFT. • The LEEFT is low-cost, highly efficient, and produces no DBPs. • The LEEFT can potentially be applicable for water disinfection at all scales. Water disinfection is a critical step in water and wastewater treatment. The most widely used chlorination suffers from the formation of carcinogenic disinfection by-products (DBPs) while alternative methods (e.g., UV, O₃, and membrane filtration) are limited by microbial regrowth, no residual disinfectant, and high operation cost. Here, a nanowire-enabled disinfection method, locally enhanced electric field treatment (LEEFT), is introduced with advantages of no chemical addition, no DBP formation, low energy consumption, and efficient microbial inactivation. Attributed to the lightning rod effect, the electric field near the tip area of the nanowires on the electrode is significantly enhanced to inactivate microbes, even though a small external voltage (usually<5 V) is applied. In this review, after emphasizing the significance of water disinfection, the theory of the LEEFT is explained. Subsequently, the recent development of the LEEFT technology on electrode materials and device configurations are summarized. The disinfection performance is analyzed, with respect to the operating parameters, universality against different microorganisms, electrode durability, and energy consumption. The studies on the inactivation mechanisms during the LEEFT are also reviewed. Lastly, the challenges and future research of LEEFT disinfection are discussed.